Tilt switch TC-1, TC-2, TC-3 vertical tilt switch TC-1, TC-2, TC-3 vertical tilt switch TC-1, TC-2, TC-3. The working principle of vertical tilt switch TC-1, TC-2, TC-3 is to suspend the sensor in the tank compartment with a cable. When the material accumulates and tilts the sensor, it receives a switch and outputs a signal. After the accumulation is released, the contact signal returns to the initial state. There is a metal ball inside the main body of the tilt switch. When it remains vertical, the metal ball is in the center position and the micro switch is pressed. When the main body tilts more than 17 degrees; When the metal ball rolls, it leaves the micro switch and outputs a contact signal& TC-1 Technical Parameters& nbsp;   Quantity: Approximately 11kg (cast iron shell) Two wire contact output: SPDT× 1. Contact capacity: 250VAC& 10A working temperature: -10 ℃~+120 ℃ (without condensation or icing) Protection level: IP56; Line; Mouth: 1/4~3/8 inch cable, 1/2 inch screw TC-3 technical specifications heavy& nbsp;   Quantity: Approximately 1.3kg (cast aluminum shell) Two wire or three wire contact output: SPDT× 1. Contact capacity: 250VAC& 10A working temperature: -10 ℃~+80 ℃ (without condensation or icing) Protection level: IP56; Line; Mouth: 1/4~3/8 inch cable, 1/2 inch screw NBN15-30GM50-Z0& nbsp;NBB15-30GM60-WS  NBB10-30GM50-Z0  NBN8-18GM60-WS   NBN8-18GM40-Z0   NBN8-18GM50-E0    NBB5-18GM50-Z1   NBN4-12GM40-Z1   NBN15-30GM50-E2  NBB10-30GM50-E2