Conveyor belt with flashing indicator light rope switch FJ-ET-A-II Conveyor belt with flashing indicator light rope switch FJ-ET-A-II Conveyor belt with flashing indicator light rope switch FJ-ET-A-II Contact type and quantity: two sets of normally open and normally closed contacts& AC380V5A action angle& 30 degree limit angle& 60 degrees& nbsp;   Working voltage 0V-450VAC/DC& nbsp;   Reset method& nbsp;  Manual& nbsp;   Protection level; IP67     Action power& 10KG Reliability& >100000 times ambient temperature& -40~50 degrees relative humidity& 0-95% atmospheric pressure; Main technical advantages of 80-110KPa:; After the switch is activated, the flashing light starts to flash, prompting the operator to quickly identify the fault point of the switch, reset the switch, and shorten the time for troubleshooting& 2. When a certain rope switch is pulled down, the flashing light starts to flash, indicating that the switch is activated for maintenance personnel to carry out maintenance work& When a rope switch contact is mistakenly activated, the flashing light starts to flash, providing guidance for maintenance personnel to find faults& 4. This rope switch adopts a plug-in terminal block for wiring, making it convenient for users to connect and find faults& 5. This rope switch comes with a junction box, which solves the problem of welding junction boxes near the on-site rope switch for users. It makes it convenient, neat, and aesthetically pleasing for users to install rope switches, improving the level of enterprise civilization production. Belt Tight Stop Controller& nbsp;     Belt rope switch: also known as emergency stop switch or belt protection switch, it is mainly a belt protection device used for emergency shutdown in case of accidents at the material conveying site& nbsp;     The rope switch consists of a pull rod, a reset handle, a cam, a locking groove, and a micro switch. The pull rope switch is installed on the frames on both sides of the belt conveyor, and is connected along both sides of the conveyor with a steel wire rope. Maintain a distance of 25-30m between the two pull rope switches, using a steel wire rope with a diameter of 4mm for connection, and the tension should be moderate. To reduce the impact of the weight of the steel wire rope on the switch and cause erroneous actions, a support ring will be welded to the frame every 3 meters to support the steel wire rope and ensure its normal operation. When an emergency occurs in the conveyor belt equipment, the steel wire rope is pulled at any location along the site, and the steel wire rope drives the drive arm to rotate. The precision cam is displaced by the torque spring driven by the transmission shaft, driving the control line and stopping the conveyor. Pull rope switches are widely used in industries such as power, coal mines, building materials, docks, metallurgy, and are specialized in belt conveyors for bulk material transportation& nbsp;