Overview of KLA-D-S Bidirectional Rope Switch: Widely used in factories and mines with belt conveyors such as steel, cement, power plants, and mines. This product is installed on both sides of the belt conveyor and is a protective switch used for emergency shutdown of the belt conveyor. It pulls the steel wire rope at any point within the operating distance of the switch, cuts off the running circuit, and stops the entire line, achieving protection for the safety of the belt conveyor and people. Working principle: When an emergency occurs at the tape transportation site, pulling the steel wire rope tied to the lifting ear is triggered by the sliding block and switch inside the machine, which sends a stop signal. After releasing the steel wire rope, the switch automatically resets. Technical parameters: Operating environment conditions: Environmental temperature: -30 ℃~+50 ℃ Relative humidity: not less than 85% Action angle: 30 ° Extreme angle: 60 ° Action force: 10Kg Contact quantity: 1 normally open and 1 normally closed Contact capacity: AC380V/5A Reset method: Automatic reliability:>106 times Protection level: IP65 Heavy& nbsp;     Quantity: 2.5Kg Usage and installation: The switch is balanced and pressed onto the fixed bracket of the rack; Tie the steel wire rope to the pull rings at both ends, with each side of the rope not exceeding 40m (shortened when there is a slope); The tension rope pressure should be appropriate to ensure reliable reset of the switch; The pull rope is set parallel to the tape, with a lifting ring added every 10 meters. Steel wire ropes can be purchased by the manufacturer according to the specifications required by the user< br/>